Create an account, add the hub to the application, and create at least one room.
AJAX SPACECONTROL INSTALL
Following the hub instruction recommendations, install the on your smartphone.In this operation mode, the key fob commands are not delivered to the security system.īattery replacement Connecting the key fob to the Ajax Security System Connection to hub Key fobs with firmware version 3.53 and latest do not function when the battery charge level is unacceptably low, do not communicate commands to the hub, and do not notify with LED indication The battery charge level is unacceptably low. In this case, the key fob commands are delivered to the security system.īattery replacement Firmware version 3.16 and lowerĬontinuous short flashes of red when a key fob with firmware version from 3.18 to 3.52 is used. What is system integrity check? Firmware version 3.16 and lowerĪfter the main indication, the central LED lights up green once and gradually goes outĪfter the main indication, the central LED lights up red once and goes out gradually The key fob battery needs replacement.
AJAX SPACECONTROL VERIFICATION
The central LED lights up red for approximately half a second The system has not executed the key fob command - integrity verification is enabled in the system and one of the devices is faulty The central LED lights up green for approximately half a second The system has executed the key fob command Firmware version 3.18 and higher Then 4 key fob LEDs blink green 6 times The key fob has been removed from the security system devices The central LED lights up green for a few seconds Linking a key fob to the security system Firmware version 3.18 and higher The central LED lights up red briefly The command has not been delivered as the security system is too far away and cannot receive the command Two LEDs next to the button light up green twice. The LEDs next to the pressed button quickly blink green 4 times Indication Event 4 green key fob LEDs blink 6 times The key fob is not registered with any security system Two green LEDs next to the pressed button light up once The key fob command has been sent over to the security system Firmware version 3.16 and lower Information about the firmware version is displayed at the very bottom. You can find out the firmware version in the Ajax application Devices key fob. Type and color of indication of the key fob display depends on the firmware version of the device. The key fob reports its status only after any button is pressed. To turn off the actuated security system (siren), press the disarming mode button (C) on the keyfob.Īccidental click protection is available on the SpaceControl with firmware version 5.54.1.0 and higher.
0 kommentar(er)
